Silicone Toes Prosthetic Pair for Underdeveloped Toes, Louise
These natural, hyper-realistic silicone rubber toes prosthetics are designed by the artist, EBL, for those with underdeveloped toes. They are made for special occasions and light wear. They are completely hollow except for the filled toe tips underneath nail area.
The Louise collection is modeled from a woman in her early 30's. These flex-fit, high quality prosthetics are made with a very thin and stretchy bottom edge for seamless transition onto the skin. Acrylic nails are permanently adhered and can be painted with nail polish.
Please allow one month for these to be made especially for you.
Each prosthetic is treated as an individual work of art and is handmade by the fine artist, EBL, in her home studio in the foothills of New England.
PLEASE READ FULL DESCRIPTION BELOW
CARE
These prosthetics are designed for cosmetic use and light wear. They are not designed for daily wear, manual work, gardening, etc.
They should be cared for like a fine piece of jewelry.
Store your prosthetic in the gift box provided so the thin edges are not distorted or under any pressure.
Wash the prosthetic gently in a solution of hot water and mild liquid soap.
Remove all vaseline from the interior and pat dry with a paper towel.
Do not rub the surface of the prosthetic excessively.
HANDLING
Prosthetic can be rolled on or...
Apply a thin layer of vaseline onto your residual foot.
Gently slide the prosthetic into place on the residual foot.
To remove the prosthetic, gently squeeze the prosthetic to break the vacuum.
Pull the prosthetic gently off by rotating until it is removed completely.
Do not pull or grip the thin edge of the prosthetic because it can tear easily.
Discontinue use immediately if you experience any discomfort.
CUSTOMIZE TO FIT
Included is a sample kit of a waterproof skin-safe adhesive that can be used to fill the hollow cavity of the prosthetic so the interior takes on the same shape as your residual foot.
Once you figure out how much adhesive needs to be added to your prosthetic, roll back the thin wall, leaving a cup shape where you will fill the prosthetic with adhesive.
Mix equal parts A + B and apply to the inside of the prosthetic.
Immediately place the prosthetic on your foot by rolling the edge back down over your foot.
The adhesive will cure in 5 minutes and become a permanent part of the prosthetic.
Remember that the adhesive is silicone, as well as your prosthetic, so any adhesive that is added to your prosthetic will stay on it permanently.
MATERIAL
Water-Resistant Platinum Silicone Rubber. This rubber is very flexible and stretchy; It feels like real skin.
Acrylic nails can be painted with nail polish, which can be removed with non-acetone nail polish remover just like a real nail.
*There are no fingerprints.
MEASUREMENTS
All measurements are in INCHES
CIRCUMFERENCE: the distance around the circular base of the prosthetic
LENGTH: the measurement from end to end
Right & Left Foot Measurements may vary slightly
Small Foot:
7 1/4 inches circumference around base of prosthetic
Length from base to tip of big toe: 3 1/2 inches
Width across toes: 3 inches
Big toe measures 1 1/2 inches long
Big toe measures 1 inch across widest
Large Foot:
8 1/4 inches circumference around base of prosthetic
Length from base to tip of big toe: 4 inches
Width across toes: 3 1/4 inches
Big toe measures 1 3/4 inches long
Big toe measures 1 1/8 inches across widest